Salt Water System Upgrade - £1,250
Eliminate Bromine Tablets and Floater
You’ll never again have to buy, transport, store or load bromine tablets into a feeder.
ELIMINATE QUARTERLY DRAINING - With this technology, your water change interval can be extended up to a full year.
REDUCE REGULAR SHOCKING - The biggest reason you currently shock your water is to burn off by-products created by your sanitizer. Since these will not be present, most shocking will not be necessary.
REDUCE SCUM LINES - Scum lines are usually caused by inconsistent sanitizer levels
REDUCE FOAMING - Chemical by-products are a big contributor to foaming. This system eliminates sanitizer by-products, therefore you will notice a drastic decrease in the amount of foam in your spa.
How does the technology work?
First, sodium bromide (“NaBr” - a close relative to sodium chlorine - “NaCl” - otherwise known as table salt) is added to your spa’s water. The dissolved bromide ions are circulated through a bromine generating contact cell located in your spa plumbing. This converts the bromide ions into free bromine (bromine is the recommended sanitizer for hot tubs and spas) before reverting back to sodium bromide —- thus completing the perpetual cycle. Additional sodium bromide is only added when your water level declines due to splash out, or when you drain and refill the tub.
The system’s electrodes are comprised of high density, ultra-porous “graphite”. The controller operates at extremely low DC voltages, resulting in the electrical cost of operation at just pennies a day. Synthetic graphite is utilized in the revolutionary electrode cell, providing a surface area far greater than available with metal electrodes. The electrode is made up of 2 of these unique and powerful plates. The plates measure 1 inch wide by 8 inches long and 1/2 inch thick.
The electrodes are virtually impervious to harsh chemicals and the oxidation process. Still, over time, the flow of water will erode the replaceable cell. The cell carries a full five year warranty. The system will be installed neatly inside any spa cabinet by one of our qualified technicians! The electrode cell is mated to a simple 2” slip x slip X-threaded tee fitting and is then connected to the DC-out wires of the controller. Less than 30 watts of total DC power is digitally pulsed across the electrode cell, producing bromine from bromide salt.
